Palm vs Claw vs Fingertip Mouse Grip
Learn where your hand touches the mouse in each grip and what shell shapes leave room for the way you move.
Palm grip uses broad palm contact, claw grip usually braces the back of the palm with bent fingers, and fingertip grip leaves the palm off the shell. Look at where your hand touches the mouse during the movements you make most often. A useful grip label tells you what the shell should support and where it should leave room.
Palm grip needs room for your hand to settle
With palm grip, much of the palm rests against the body and your fingers extend toward the buttons. Look for a shell that supports the part of the palm that naturally carries your hand. An ergonomic right-handed shape can be an option if you like a slope under the palm. A symmetrical shell with enough height and width may also give you the contact you want.
Try scrolling and clicking for several minutes. If you have to slide forward to reach the wheel, try a shorter shell or a model with the wheel farther back. If your fingers overhang the buttons, compare a longer shell or look at where the usable buttons begin.
Claw grip uses a rear contact point
With a claw grip, the fingers bend more and the back of the palm may anchor against the rear of the mouse. That contact can feel quite different on two mice of equal length. A tall rear hump can fill the gap behind your knuckles. A lower rear lets you keep more room between the shell and the palm.
In a relaxed claw grip the fingers are less curled and more of the palm may rest on the shell. Start by checking where the back of your hand lands on your current mouse. If a taller hump pushes your wrist or fingers out of the position you use naturally, compare a gentler side profile.
Fingertip grip leaves room inside the palm
Fingertip users steer with their fingers and thumb, often pulling the mouse back slightly for small corrections. A shorter body can leave more room for that motion. Check the height of the buttons and the width where you actually hold the sides. Both can change how far you have to reach or spread your fingers.
If the heel of your palm occasionally touches the shell while you steady the mouse, you may sit between claw and fingertip. The relevant comparison is whether that contact helps during a longer move or gets in the way when you need to pull the mouse back for a smaller one.
You can compare this with your current shell by repeating the same motion once with light rear contact and once with the palm floating. Notice which gives you more room to stop.
Test the grip you use rather than the pose you can hold
- Move the pointer between two nearby targets. Notice how much of the motion comes from your fingers.
- Make a wider sweep and lift the mouse to reset. Check whether you change your grip or squeeze the sides during the lift.
- Scroll, click and try the buttons you use routinely. Notice whether your thumb can find them from its normal position.
- Repeat after a few minutes of an activity you care about. Your relaxed grip often becomes easier to identify once you stop thinking about it.
Choose the shell around your normal movement and the contact points that help it.
Logitech G demonstrates grip differences on a few gaming mice in the video below. Use it to see how the fingers and palm land, then compare some shapes in the mouse catalog. If you still have several sensible options, measure your hand and compare similarly sized shells with different hump positions first.